Friday, December 28, 2018
Need to make a new mount for mounting the Dewalt DWP611 to the zAxis carriage.
This is where the router will be mounted.
Next is somehow attaching the superPID controller onto the spindle mount.
Then finally with some sheet metal, fabricate a enclosure for the components.
On converting my Dewalt WP611 to be controlled by superPID, I followed Adam David's instructions at http://www.adamdavid.me/home/router/dewalt-router-superpid-conversion. However I didn't like the way the sensor wire was poking out , and had to be wrapped around to secure it to the AC wires.
Hole drilling Location